ETM SERIES The ETM series is equipped with state of the art technologies meant to bend with or without mandrel tubes and profiles, and capable of bending both in right and left direction. The range in diameter is from 1/2 inch up to 3 inches and can make curves over 180° with top finish quality for a minimum bending radius of 3 x the tube diameter. Thanks to our new “Digital Bend Programming Touch Screen”, these machines are extremely easy to use: it enables selection of up to 99 programs each of them with a 5-stop sequence in the bending operation with automatic adjustment for material springback. Moreover, it can also save and store each project as a repeatable program.
Cycle Speed 4 seconds /90 no load / 3.5 rpm Max Bend Angle 180 degrees + spring back Speed Reduction Oil Bath with solid stock gears Motor Power 2.75 HP. Self Braking TEFC 3 Phase 220V* Weight 418 LBS without tooling